Manual - Holdan.eu

For use with dual-channel scalers such as the C2-7000 series, connect your
video source (e.g. a DVD player or computer) to an input on the C2-7000 unit.
It is not necessary to feed two signals – the C2-7000 unit can use the same
signal for both outputs.
For 2 single-channel scalers, you can either use a distribution amplifier so that
a single video source is split into 2 signals, or use the ‘loop’ output available
on some units.
12.5 Initial setup
This section describes how to start setting your scaler up. It is vital that your
scaler is ‘clean’ of any user settings, so it is advisable to perform a full factory
reset by either re-updating the firmware, or doing a factory reset (see earlier in
manual for how to do this).
a
b
c
Showing setup of zoom for each channel.
Figures ‘a’, ‘b’ and ‘c’ show how an original wide-screen image is ‘split’ into
two using identical zoom values on Output 1 and Output 2. Zoom values for