Manual - Holdan.eu

Press and hold the macro button (using SHIFT if needed) until the unit
gives a short beep and the display says Info: Added to Macro. This has
now added the Shrink position for window 1A to the macro
The macro is now complete. Pressing your RESTORE button will
return the unit to the last saved state. Pressing your macro button will
return the unit to Dual PIP mode with window A shrunk to 50% and
moved to the left hand side of the screen and positioned over Window
B
11.3 Standards Conversion – NTSC to PAL
For this example you will need a video monitor connected to Composite video
output 1, and an NTSC playback source connected to Composite video input
1.
Change mode:
Move to the top of the menu structure and change the device mode to
Independent.
Change the output:
Enter the Adjust outputs menu
Go to the ‘Output res’ screen
Change the resolution to be Resolution number 2 (PAL)
Exit the Adjust outputs menu
Select the input source
Enter the adjust windows menu
Go to the Source screen
Change the source for 1A to be CV1 (our NTSC source)
You should now see the Playback source on the monitor at PAL resolution
and encoding.