Manual - Holdan.eu

Dual PIP Mode Method (One or Two Key Channels, Locked)
Change mode:
Change Mode to Switcher
Setup the lock source
Enter Adjust Outputs menu.
Select Output 1.
Set Lock to Lock & Mix.
Set the lock source to be a valid Input source
Set Output Type to desired setting
Setup first key source:
Enter Adjust Windows menu.
Select Window A.
Select Source for the window.
Adjust Shrink Level to 50%. Allows window B to be shown behind
window A (Window B will default to RGB1 as a source, we will change
this later)
Adjust H/V Shr Pos % to be 0,50. Positioning the Window to the far left
middle of the output
Exit Adjust Windows menu
Enter Adjust Keyers menu
Turn Keyer On.
Increase Y Key Max until target color disappears.
Increase Y Key Min until reappears, then decrease until it disappears
again.
If the edges appear rough, increase the Y Key softness.
The Key Min/Max may need to be readjusted after making the softness
adjustment.
Y Key Invert will cause the portion that is currently keyed out to
become solid and the rest transparent.
Increase U Key Min until reappears, then decrease until it disappears
again.
Decrease U Key Min until reappears, then increase until it disappears
again.
If the edges appear rough, increase the U Key softness.
The Key Min/Max may need to be readjusted after making the softness
adjustment.
Increase V Key Min until reappears, then decrease until it disappears
again.
Decrease V Key Min until reappears, then increase until it disappears
again.
If the edges appear rough, increase the V Key softness.