Manual - Holdan.eu
Manual - Holdan.eu
Manual - Holdan.eu
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
System<br />
Autoset sense<br />
[Medium]<br />
In order for Autoset to work properly, it needs a sufficiently bright full-screen<br />
image to examine. The sense level lets you change the brightness threshold<br />
for detection of the screen edge between Low, Medium, High and V.high.<br />
Medium is the default level, which is recommended for normal use (Windowstype<br />
images, etc.)<br />
System<br />
OSD on power up<br />
[On]<br />
This parameter controls whether the ‘welcome’ screen is displayed or not on<br />
power up for units with an on-screen display – it can be disabled as required.<br />
This is useful when a unit is installed as part of an overall system.<br />
System<br />
Advanced Menus<br />
[Off]<br />
When turned on, the previously explained Adjust resolutions menu structure is<br />
exposed. The default condition is ‘Off’, to prevent accidental changes.<br />
System<br />
LED brightness % [ 90]<br />
This parameter is available on certain units and controls how bright the LEDs<br />
on the front panel appear.<br />
System<br />
RS232 baud rate [57600]<br />
This menu item allows the adjustment of the serial baud rate used for RS-232<br />
communications. The rate can be adjusted to 9600, 19200, 28800, 33600,<br />
38800, 57600 and 115200. (This adjustment is provided for those instances<br />
where you wish to use the RS-232 control system for your own purposes.)<br />
The default baud rate is 57600.<br />
System<br />
Buzzer<br />
[ On]<br />
The screen labeled ‘Buzzer’ is actually the control for turning the “Beep” “On”<br />
or “Off”. Normally this is left in the “On” position to provide positive feedback<br />
that your data entries and parameter changes have been accepted.