Manual - Holdan.eu
Manual - Holdan.eu
Manual - Holdan.eu
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Adjust ethernet<br />
IP enabled<br />
[Auto]<br />
This parameter has three possible states: On, Off and Auto. On and off<br />
manually control the Ethernet capability of the unit. When in Auto mode, if a<br />
valid Ethernet connection is present, remote control of the unit will<br />
automatically default to Ethernet and control via RS-232 is disabled whilst that<br />
connection is maintained.<br />
Adjust ethernet<br />
IP add. [ 10] 1 2 123<br />
Enter 4 numbers one by one to form the IP address you wish to assign to the<br />
unit. The IP address is a series of four numbers between 0 and 255. Anything<br />
above 255 is not a valid number in an IP address range. The unit will not allow<br />
you to go above 255.<br />
The IP address must be a unique address on your network, and also must be<br />
within the sub-net of your network. If you are unsure about which IP address<br />
to use or don’t have a unique IP address, ask your Network Administrator.<br />
Adjust ethernet<br />
IP sub. 255.255. [255.000]<br />
Adjust the last 2 numbers to set the sub-net address (also know as sub-net<br />
mask) of your network. Again, if in doubt ask your Network Administrator.<br />
Adjust ethernet<br />
IP gtwy. [ 10] 1 2 123<br />
Enter your network’s gateway IP address into this menu item. Again, if in<br />
doubt ask your Network Administrator. In general, the gateway only needs<br />
setting if the unit is being controlled from a different network (e.g. via the<br />
internet).<br />
Adjust ethernet<br />
IP port [10001]<br />
Enter the IP port number you wish the unit to communicate on. Keep a note of<br />
this as it will be needed when using other devices to communicate with the<br />
unit e.g. CC-300.<br />
1A Adjust Ethernet<br />
Set new IP data & reboot<br />
Certain units require a re-boot once the new IP address has been entered.<br />
Once activated, all current settings (including other menu items) will be saved<br />
and the unit will re-boot.