Manual - Holdan.eu

It is recommended that you Store your settings once you’re happy with them
in readiness for future use.
Source: RGB1
Source to adjust
[RGB1]
This menu item selects the input connection for which you want to make
adjustments to. As in the image above, changes will only be made to the
source connected to RGB1. Once the selection has been made, all changes
made using the following operating parameters will only apply to the selected
input.
Selection of a CV/YC source will reveal different menu
items that allow adjustments beyond those used for RGB
sources. The menu discussions that follow relate first to
RGB sources, then to CV / YC type sources.
8.10.1 RGB Source Menu Items
Source: RGB1
Autoset status
[Inactive]
Once the Autoset sense setting has been made, this menu item is accessed
and activated. The Autoset sense utility will then correct the pixel phase and
then position the Top Left portion of the image and the Bottom Right portion of
the image. Once complete it then resume inactive status.
Source: RGB1
TL pos. adj. [ 0] [ 0]
This menu item allows manual positioning of the Top and Left portion of the
image. It is used to ensure that the input signal is captured correctly,
eliminating any black borders. These settings are often used to correct the
position of a PC signal on an input, or to eliminate any undesired noise at the
top or bottom of a PAL or NTSC video source.
Source: RGB1
BR size adj. [ 0] [ 0]
This menu item allows manual positioning of the Bottom and Right portion of
the image. These settings are often used to correct the position of a PC
signal on an input, or to eliminate any undesired noise at the top or bottom of
a PAL or NTSC video source.
Source: RGB1
Audio input [ 1]