Manual - Holdan.eu
Manual - Holdan.eu
Manual - Holdan.eu
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Adjust borders<br />
Border enable<br />
[On]<br />
Allows a border to be turned off and not displayed on the output screen.<br />
Adjust borders<br />
Brdr size H/V [8] x [8]<br />
This adjustment allows the height and width of the border to be changed it can<br />
be up to 255 pixels thick.<br />
Adjust borders<br />
Brdr offset H/V [0] x [0]<br />
This allows the border to be offset from the window. A typical application is<br />
the creation of a drop shadow effect. For example this can be achieved by<br />
setting the border size to 0 and then adjusting the H and V offset to 10 pixels.<br />
Adjust borders<br />
Brdr Y/U/V [16] [128] [128]<br />
The color of the border can be changed to any color by adjusting the Y, U and<br />
V parameters. Y is the luminance, with U and V altering the blue and red<br />
content respectively. E.g. increase both U and V to give a purple colour, or<br />
decrease both to give a green colour.<br />
Adjust borders<br />
Brdr opacity % [100]<br />
This parameter controls how visible the border is to the viewer. A setting of 0<br />
renders the border invisible (transparent) whereas a setting of 100 makes the<br />
Logo fully visible. (In-between settings can give the Border a transparent<br />
appearance.)<br />
8.10 Items Associated with the Adjust sources group<br />
The ‘Adjust Sources’ menu group accesses the parameters associated with<br />
the processing amplifiers used for each input (RGB, CV, YC, etc.). They<br />
allow you to fine-tune an incoming signal to optimize its color, brightness or<br />
even sharpness.<br />
Not all settings are available for all input types, and not all input types listed<br />
here may be available on your unit.