Manual - Holdan.eu

C2-7000 SERIES OPERATION MANUAL
8.0 MENU TOPOGRAPHY AND ADJUSTMENT METHODOLOGY.............35
8.1 The High Level Menu Structure.........................................................................36
8.2 Group Names and Descriptions.........................................................................37
8.3 Items Associated with the Device mode group................................................... 37
8.4 Items Associated with the Adjust outputs group................................................. 37
8.5 Items Associated with the Adjust windows group............................................... 39
8.6 Items Associated with the Adjust keyers group.................................................. 42
8.7 Edge Blend items within the Adjust keyers group .............................................. 44
8.8 Items Associated with the Adjust logos group .................................................... 45
8.9 Items Associated with the Adjust borders group ................................................ 46
8.10 Items Associated with the Adjust sources group................................................ 47
8.10.1 RGB Source Menu Items................................................................................... 48
8.10.2 CV & YC Source Menu Items ............................................................................51
8.10.3 Testcard Source Menu Items.............................................................................52
8.11 Items associated with the Adjust transitions group.............................................52
8.12 Items Associated with the Adjust buttons group................................................. 53
8.13 Items associated with the Adjust ethernet group................................................ 53
8.14 Items associated with the Adjust resolutions group............................................55
8.15 Items Associated with the System group ...........................................................58
9.0 RS232 PORT........................................................................................... 62
9.1 Connection ........................................................................................................62
9.2 Communications protocol .................................................................................. 62
10.0 RS232 / IP CONTROL SPECIFICATION ................................................63
10.1 Communication protocol basics.........................................................................63
10.2 Packet format ....................................................................................................64
10.3 Function list ....................................................................................................... 66
10.4 Examples...........................................................................................................71
10.5 Reading and writing macros .............................................................................. 72
10.5.1 Reading a previously stored Macro....................................................................73
10.5.2 Writing to a macro.............................................................................................. 73
10.5.3 Run and Restore macros................................................................................... 74
11.0 COMMON OPERATIONS........................................................................75
11.1 Operation of the Keyer.......................................................................................75
11.2 Creating a Macro ............................................................................................... 80
11.3 Standards Conversion – NTSC to PAL .............................................................. 81
12.0 EDGE-BLENDING SETUP ......................................................................82
12.1 Introduction........................................................................................................82