Manual - Holdan.eu

then press button number 1 to toggle between Output 1 and 2.), or via the
dedicated input selection buttons on a 48-key panel.
The function of the A B & Z buttons in this mode allows you to change
between the active window for the Output and Window Z only. E.g. With
Output 1 selected you can select Windows A and Z; with Output 2 selected
you can select Windows B and Z.
Select the desired input by pressing the appropriate button. When the button
is pressed, the image will immediately appear on the output. Select Output 2
(Shift & button number 1 on the 10-key front panel) to change to the other
output. Repeat the activity to make your selection for the second video path
and note the LCD display is changing from 1A to 2B during the process.
As a part of this familiarization exercise, you may wish to resize the images by
using either using button number 9 and the shift key on the 10-key panel, or
the dedicated PIP & SIZE buttons on the 48-key panel.
7.3 Operating the Unit in Picture In Picture Mode (Dual PIP)
The Picture In Picture mode is a very powerful function available on the C2-
7000 series because unlike many products on the market, you have two P-I-P
functions available and each is independent of the other with respect to signal
type and content.
As before, the frame of reference will be the Factory Default condition. At this
time, perform the Factory Reset as explained in section 5.2 above.
After the system resets, the initial screen will once again be as follows:
CORIO2 C2-7100
TV One
Change the Mode to Dual PIP as shown below:
Device mode
Mode [ Dual PIP]
7.3.1 Selecting Inputs for the Individual Windows
10-key front panel: button 1 toggles between the Window “Z” (The Lock
Source), Window “A” and Window “B”.
48-key front panel: use the dedicated input selection buttons.
Since there is no Lock Source automatically selected in the Factory Default
and Lock mode is set to off, nothing will happen on the screens when you
have the Z Input Source selected.