Manual - Holdan.eu
Manual - Holdan.eu
Manual - Holdan.eu
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
7.0 CHANGING THE OPERATING MODE<br />
As previously explained, the C2-7000 series has two independent video<br />
processors and three operating modes: Switcher Mode, Independent Mode<br />
and Dual Picture in Picture (Dual PIP) Mode.<br />
Within these three modes there are over 20 additional functions that can be<br />
accessed either within a single channel or layered across both channels.<br />
These individual functions will be explained later in the manual but for now, it<br />
would be well to learn the basics of the three modes. The discussions that<br />
follow are all referenced to the C2-7000 series’ default condition upon initial<br />
application of power or after a Factory Reset has been performed.<br />
7.1 Operating the Unit as a Video Switcher<br />
When the C2-7000 series is initially turned on the first time (and after any<br />
Factory Reset), it will be in the Switcher mode. If a mode change is made to<br />
either Independent mode or Dual pip mode, and the power is not totally<br />
removed from the unit by unplugging it from the AC supply, the last selected<br />
mode will be retained even if the unit is switched off using the power switch.<br />
In the following discussion, the assumption is made that the unit is being<br />
turned on for the first time and is therefore in the Factory Default condition.<br />
Connect the DVI-I #1 Output to either a DVI-I compliant monitor or to a RGB<br />
Analog Component monitor using appropriate adapters if necessary. Connect<br />
a second monitor to the DVI-I #2 Output. These will become your Program<br />
and Preview monitors respectively.<br />
By changing the Output Resolution to NTSC/PAL and type to CV/YC, you can<br />
also connect monitors to the Composite Video or YC Video Outputs (instead<br />
of RGB), however the quality of the signal will not be as good as the signal<br />
present at the respective DVI-I / RGB outputs.)<br />
CORIO2 C2-7100<br />
TV One<br />
The LCD screen will display the model number when you initially apply power<br />
to the unit or perform a reset, you should make note of this number in case<br />
you require technical assistance.<br />
Device Mode<br />
Mode [ Switcher]<br />
If not in the Switcher mode, press the Rotary Encoder or Multi-directional<br />
Switch (depending on your front panel version) and the brackets portion of the<br />
display will begin to flash. Adjust the Mode and then press again to stop the<br />
brackets flashing (indicating that you’re no longer adjusting that feature).