Manual - Holdan.eu
Manual - Holdan.eu
Manual - Holdan.eu
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Power is never totally removed from the unit when it’s plugged into an active<br />
AC outlet. Pressing the button at the extreme right on the front panel only<br />
places the unit in a powered down mode. This button is a standby switch, not<br />
a true off and on switch. Never remove the unit from a cabinet unless the unit<br />
has been completely disconnected from AC power.<br />
5.2 Factory Reset<br />
For the 10-key programmable front panel: to restore all operational<br />
parameters to their original condition, first ensure the unit’s in the operational<br />
mode, green power led illuminated (not in Standby red power led illuminated).<br />
If it is in the operational mode, hold the standby switch and then hold Buttons<br />
“1” and “2” until the unit beeps.<br />
For the 48-key front panel: to restore all operational parameters to their<br />
original condition, first ensure the unit’s in the operational mode (not in<br />
Standby red power led illuminated). If it is in the operational mode, hold in the<br />
SHIFT and RESTORE buttons together until the unit beeps multiple times –<br />
the first beep indicates that a restore to last-saved settings has occurred, the<br />
second that a factory reset has occured.<br />
All stored settings except resolutions are lost when the unit is reset. A<br />
Firmware update is the only way to perform a complete factory reset<br />
5.3 Initial Operation Check Using Factory Default Settings<br />
The C2-7000 series can be operated via the Front Panel Buttons, an LCD<br />
display and a Rotary Encoder or multi-directional switch (depending on your<br />
front panel version), via a Windows based utility or via a dedicated CORIO®<br />
Console hat mimics the operation of a classic video switcher. For the<br />
purposes of initially acquainting you with the operation of the unit, this manual<br />
will address the operation using the Front Panel controls.<br />
Connect the AC power cable to the unit. (Refer to the diagram below. The AC<br />
power cable connects to the socket labeled “Power 100v – 240v 47-63Hz”<br />
located on the left side of the rear panel as shown.)<br />
We’ll be using a Personal Computer for a signal source. Make certain that the<br />
monitor resolution can display 1024 x 768 @ 60Hz as this is the default output<br />
resolution for the C2-7000 series.<br />
Disconnect the cable going from a Personal Computer’s Monitor to the<br />
Personal Computer. Connect the output from the PC video card (the PC