Manual - Holdan.eu

Figure 16 Add resolution to table
Once your new resolution is added, you can program the resolution into the
Scaler using the Communications menu and then selecting Program into
unit and then selecting Program Resolutions. The application will proceed
to program all the resolutions on the list into the scaler.
Note that this will overwrite any resolutions currently in the scaler.
The second method of creating a resolution requires you to know all the
detailed timing parameters. The timings tab allows all the detailed video timing
information to be added and altered, including the title of the resolution entry
(limited to 24 characters).
There are also along side the detailed timing parameters several flags that are
used to specify the signal type these are interlaced – for interlaced video
signals, CCIR for video that would normally be output on CV or YC
connectors and RGB for video that would be output on RGB or Component
type connections.