Manual - Holdan.eu
Manual - Holdan.eu
Manual - Holdan.eu
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
13.5.1 Loading Testcards<br />
Figure 12 Testcard loader<br />
To program a Testcard into the unit select the ‘Testcards’ tab from the image<br />
programmer screen and then press Load Image.<br />
You can select JPEG, BMP and GIF images. The image will be loaded and<br />
shown on the screen. You should then enter a name for the Testcard – this<br />
name, limited to 24 characters, will be shown on the unit when it is selected<br />
as a source.<br />
The Testcard number is the ‘slot’ that the Testcard will be loaded into within<br />
the unit, there are between 10 and 15 ‘slots’ available depending on the unit<br />
type.<br />
Pressing program will convert the image into its raw RGB values and then<br />
compress it, if the image is too large once compressed then the programming<br />
sequence will stop and report that the image is too large / complex.<br />
Selecting the ‘Reduce image size to fit memory’ option will cause the<br />
application to automatically shrink the image and then recompress until the<br />
image will fit into the units memory. This will reduce the quality and detail in<br />
the image, but make it fit into the unit. If the resizing of the image is<br />
unacceptable then the complexity of the image may need to be reduced. You<br />
should refer to 13.5.3 for a guide to producing an image that will be suitable<br />
for the memory space available in the unit.