Manual - Holdan.eu

13.0 WINDOWS CONTROL PANEL
A powerful utility is available for the C2 product range and can be downloaded
from our support web site or found on the Product CD (where supplied). To
install the application click on the setup file and follow the on screen
instructions.
Once installed you will be able to control your unit via either Ethernet or Serial
(RS232) and be able to change and store all the settings of the unit.
13.1 Opening screens
When you start the application you will be presented with a splash screen
showing the product version number and then the main screen. The toolbar
menu for communications allows you to change the communications method
that the application will use.
13.1.1 Selecting a serial port connection
Select the Communications item from the Communications toolbar. Then
click the “Serial” option on the popup window.
Figure 1 Communications – Serial
The application will support up-to 10 serial ports, all other parameters
normally associated with serial communications such as the baud rate are
already configured. The application works with a baud rate of 57600 baud
only, you should ensure that the baud rate is correctly set in the unit (System
menu on the unit – see 8.15) before trying to connect.
13.1.2 Selecting an Ethernet connection
For units where an Ethernet port is provided, select the Communications
item from the Toolbar Communications. Then select the “Ethernet” option on
the popup window, the following options will be shown.
Figure 2 Communications - Ethernet