datavideo SE-900 RS-422/232 Remote Control Protocol - Holdan.eu

*******************************************************
Command code => 69h = ASK_CH_NAME_CMD
Parameter #1 = > Channel No.: 31h~38h
--- Answer ----
Parameter #1 = > Channel No.: 31h~38h
Parameter #2 = > Name ON/OFF: 30h=off, 31h= on
Parameter #3~8= > The Name’s ASCII code: EXP:[CAM2 ]=[43h,41h,4Dh,32h,20h,20h]
Parameter #9= > NC
*******************************************************
Command code => 6ah = SET_SCREEN_MODE_CMD
Parameter #1 = > Screen mode: 30h=PST at bottom, 31h=PST at top
Parameter #2 = > Screen size: 30h=100%, 31h=90%, 32h=80%
--- Answer ---
Parameter #1 = > Screen mode: 30h=PST at bottom, 31h=PST at top
Parameter #2 = > Screen size: 30h=100%, 31h=90%, 32h=80%
*******************************************************
Command code => 6bh = ASK_SCREEN_MODE_CMD
Parameter #1 = > NC
--- Answer ----
Parameter #1 = > Screen mode: 30h=PST at bottom, 31h=PST at top
Parameter #2 = > Screen size: 30h=100%, 31h=90%, 32h=80%
*******************************************************
Command code => 6Ch = SET_OUTPUT_MODE_CMD
Parameter #1 = > 30h=YUV output, 31h=CV output
--- Answer ---
Parameter #1 = > 30h=YUV output, 31h=CV output
*******************************************************
Command code => 6Dh = ASK_OUTPUT_MODE_CMD
Parameter #1 = > NC
--- Answer ----
Parameter #1 = > 30h=YUV output, 31h=CV output
*******************************************************
Command code => 6Ch = SET_NOISE_FILTER_CMD
Parameter #1 = > 30h=bypass, 31h=Low, 32h= Middle, 33h= High
--- Answer ---
Parameter #1 = > 30h=bypass, 31h=Low, 32h= Middle, 33h= High
*******************************************************
Command code => 6Dh = ASK_ NOISE_FILTER _CMD
Parameter #1 = > NC
--- Answer ----
Parameter #1 = > 30h=bypass, 31h=Low, 32h= Middle, 33h= High
52