datavideo SE-900 RS-422/232 Remote Control Protocol - Holdan.eu

5.2.8 PREVIEW Board Command
*******************************************************
Command code => 61h = ASK_CARD_TYPE_CMD
Parameter #1 = >NC
--- Answer ---
Parameter #1 =>35h=Preview board,
*******************************************************
Command code => 63h = ASK_WORK_STATUS_CMD
Parameter #1 = > NC
--- Answer ---
Parameter #1 = > Card Type: 35h: preview board
Parameter #2 = > Status Flag: (b1=0=NTSC, 1=PAL); (b2: output mode: 0=YUV, 1=CV);
(b3: screen mode: 0=PST at bottom, 1=PST at top)
Parameter #3 = > Noise Filter mode: 30h~33h; 30h=bypass, 31h=low, 32h=middle, 33h=high
Parameter #4 = > Screen Size: 30h=100%, 31h=90%, 32h=80%
Parameter #5 = > Border brightness: (1~100): 0h~64h
Parameter #6 = > NC
*******************************************************
Command code => 64h = SET_NTSC_PAL_CMD
Parameter #1 = > 30h=NTSC, 31h=PAL
--- Answer ---
Parameter #1 = > 30h=NTSC, 31h=PAL
*******************************************************
Command code => 65h = ASK_NTSC_PAL_CMD
Parameter #1 = > NC
--- Answer ----
Parameter #1 = > 30h=NTSC, 31h=PAL
*******************************************************
Command code => 68h = SET_CH_NAME_CMD
Parameter #1 = > Channel No.: 31h~38h
Parameter #2 = > Name ON/OFF: 30h=off, 31h= on
Parameter #3~8= > The Name’s ASCII code: EXP:[CAM2 ]=[43h,41h,4Dh,32h,20h,20h]
Parameter #9= > 00h
--- Answer ---
Parameter #1 = > Channel No.: 31h~38h
Parameter #2 = > Name ON/OFF: 30h=off, 31h= on
Parameter #3~8= > The Name’s ASCII code: EXP:[CAM2 ]=[43h,41h,4Dh,32h,20h,20h]
Parameter #9= > NC
51