datavideo SE-900 RS-422/232 Remote Control Protocol - Holdan.eu

5.2.4 SDI IN Board Command
*******************************************************
Command code => 61h = ASK_CARD_TYPE_CMD
Parameter #1 = >NC
--- Answer ---
Parameter #1 =>32h=SDI IN
*******************************************************
Command code => 63h = ASK_WORK_STATUS_CMD
Parameter #1 = > NC
--- Answer ---
Parameter #1 = > Card Type: 32h: SDI IN
Parameter #2 = > Status _flag: (b0=0=off, 1=on); (b1=0=NTSC, 1=PAL).
Parameter #3 = > Input type: 36h = SDI in
Parameter #4 = > Brightness: -99~+99, default=0(80h)
Parameter #5 = > Contrast: -99~+99, default=0(80h)
Parameter #6 = > Saturation: -99~+99, default=0(80h)
Parameter #7 = > NC
Parameter #8 = > RGB Correction’s U offset: -99~+99, default=0(80h)
Parameter #9 = > RGB Correction’s V offset: -99~+99, default=0(80h)
Parameter #10 = > SDI in vertical offset value
Parameter #11 = > b0~b3=audio channel, b4=NC,
b5=0=enable to decode SDI audio, 1=disable to decode SDI audio
*******************************************************
Command code => 67h = ASK_INPUT_TYPE_CMD
Parameter #1 = >NC
--- Answer ---
Parameter #1 = > NC
Parameter #2 = >Input type: 36h=SDI in
*******************************************************
Command code => 6Ah = SET_BRIGHTNESS_CMD
Parameter #1 = > Set method: 30h=set by parameter #2 directly, 31h=Increase, 32h=Decrease
When (para#1=30h)
Parameter #2 = > Brightness value: -99~+99, default=0(80h)
--- Answer ---
Parameter #1 = > Set method: 30h=set by parameter #2 directly, 31h=Increase, 32h=Decrease
Parameter #2 = > Brightness value: -99~+99, default=0(80h)
*******************************************************
Command code => 6Bh = ASK_BRIGHTNESS_CMD
Parameter #1 = > NC
--- Answer ----
Parameter #1 = > NC
Parameter #2 = > Brightness value: -99~+99, default=0(80h)
39