Manual - Charles Industries, Ltd.

More documents

Recommendations

Info

LT–5000HQ–1 Issue 1 Print 4 DANGER Do not operate this unit without the green wire connected to the HQ Series ABS Charger and to a suitable ground connection. Making DC Connections on Terminal Block 2 (TB2) After determining the wire lengths and gauges, make the DC wiring connections to TB2. (Refer to the figure number indicated in Table 2 for the model being installed.) Use captive spade or ring terminals to make connections. The HQ series output connections consist of three positive (+) terminals for up to three battery banks. One negative (−) terminal is provided that is common for all battery banks. Use the following steps to make connections to the terminal blocks. Reference Table 2 for additional specifications. Step Action 1. Remove the fasteners to allow access. 2. Route the DC wire through the right-side access hole on the bottom of the unit. 3. Torque the DC connections (see Table 2). WARNING In accordance with ABYC E-11, a fuse or circuit breaker must be placed within 7 inches of the point of connection to the batteries, or its bus, on all ungrounded (positive +) output conductors. Also, see Coast Guard Reg. 33CFR183 subpart I. Figure 1. Wiring Diagram (Reference Table 1 for Applicable HQ Series ABS Charger Model) 8 Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
Issue 1 Print 4 LT–5000HQ–1 Figure 2. Wiring Diagram (Reference Table 1 for Applicable HQ Series ABS Charger Model) Figure 3. Wiring Diagram (Reference Table 1 for Applicable HQ Series ABS Charger Model) Charles Industries, Ltd. All rights reserved. Printed in the United States of America. 9
Page 1 and 2: Issue 1 Print 4 HQ-CHARGER MARINE E
Page 3 and 4: Issue 1 Print 4 INTRODUCING... THE
Page 5 and 6: Issue 1 Print 4 LT-5000HQ-1 8. Do n
Page 7: Issue 1 Print 4 Table 2. Minimum Wi
Page 11 and 12: Issue 1 Print 4 OPERATING THE HQ SE
Page 13: Issue 1 Print 4 LT-5000HQ-1 Return

Manual - Charles Industries, Ltd.

Create successful ePaper yourself

Delete template?

Save as template?