EY35, EY40 - Small Engine Discount

.GOVERNOR SETTING METHOD
* Set the speed control lever to the high-speed posi-
tion, and fasten it there with the
wing nut. (The
governor spring is in.)
* Check that the carburetor and throttle valve are
fully open.
* Turn the governor shaft counterclockwise, and
fasten the governor lever. (See Fig. 46.)
Install the starter motor.
8 x 30 reamer bolt ........... 2 pcs.
Spring washer .............. 2 PcS.
Washer. .................. 2 pes.
Install the operation case. (with the electric starter)
Fig. 46
6 x 8 flange bolt (5T) ......... 3 pcs.
* Two of the three flange bolts tighten the case together with the cylinder buffle and fan cover.
* Properly wire as shown in the wiring diagrams (Pages 34 and 35).
Install the muffler.
NOTE: The muffler gasket must be placed in 'the correct direction. (Non-symmetric direction)
8m brass nut ............... 2 pcs.
8 x 16 bolt (for bracket) ....... 2 pcs.
Washer. .................. 1 pce.
Install the muffler cover.
6 x 8 flange bolt (5T) ......... 4 pcs.
Install the air cleaner.
NOTE: Make sure that the tip of the breather pipe out of the tappet cover is clear off the element retainer.
6 x 12 flange bolt ........... 2 pcs.
After mounting the cleaner bottom plate, install the choke knob, element retainer, element and cover in ths order.
Install the tank bracket.
10 mm flange nut ........... 4 pcs.
(also for cylinder head)
Install the fuel tank.
8 mm No.2 nut ............. 4 pcs.
Spring washer .............. 4 pcs.
Connect the fuel pipe.
Clamp the pipe securely.
Supply 1.2 liter engine oil.
-25 -