EY35, EY40 - Small Engine Discount

*SPARK CHECK
* Clean the point surfaces of oil with paper or the like, and temporarily install the flywheel.
* Hold the high-voltage wire with hand so its end is about 5 mm away from the case, and turn the flywheel in normal
direction.
* Check that a spark is generated when the M mark on the flywheel passes the M mark on the case.
* Install the point cover.
4 x 12 screw and washer ...... 2 PCS.
11) Install the flywheel.
NOTE: Before installing the flywheef, clean the crankshaft and the tapered part of the flywheel of oil.
16mmnut ................ 1 pce.
Spring washer .............. 1 pce.
Washer. .................. 1 pce.
Tightening torque .. .800 - 1000 kg-cm
12) Install the starter pulley.
8 x 12 bolt (ST) ............ 3 pcs.
13) Install the fan cover and head cover cylinder buffle.
NOTE: Before installing the fan cover, first install the head cover on the cylinder head. Also install the muffler brack-
et in place at the same time.
6 x 8 flange bolt ............ 7 pcs.'
14) Install the recoil starter
NOTE: Pulling direction may vary with machine make.
15) Install the carburetor.
6 x 8 flange bolt ............ 4 pcs.
NOTE: Install the carburetor with the joint sheet, insulator, and paper packing in this order.
6 mm nut ................. 2 pcs.
Spring washer .............. 2 pcs.
Washer. .................. 2 pcs.
16) Install the speed control and governor lever according
to the arrangement of parts shown in Fig. 47. Hook
the governor spring at the proper hole.
8 mm wing nut ............. 1 pce.
Clip.. ................... 1 pce.
0
Fig. 45
- 24 -