EY35, EY40 - Small Engine Discount
EY35, EY40 - Small Engine Discount
EY35, EY40 - Small Engine Discount
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
~ MATCH<br />
5) Assemble the piston and connecting rod that were<br />
readied in Steps 3) and 4).<br />
NOTE: The symbol @FAN mark on the connecting<br />
rod must be on the magneto side.<br />
NOTE: Be careful of the match mark on the cap. If<br />
the match mark is at the correct position, the<br />
oil scraper should be on the main bearing cover<br />
side.<br />
NOTE: Tightening bolt . . . . . . . 8 x 46 (special)<br />
Tightening torque . . . 250 - 300 kg-cm<br />
Use new lock washers,and bend their edges<br />
securely.<br />
u__<br />
Fig. 32<br />
Install the main bearing cover.<br />
NOTE: If the oil seal is damaged when the governor<br />
CRANKSHAFT SPACER<br />
\<br />
yoke is installed, replace it with a new one.<br />
NOTE: Adjust the side clearance to anywhere between<br />
0.05 and 0.2 mm.Thesideclearance<br />
can be measured by measuring sizes A and B<br />
as shown in Fig. 33, and assume that the thickness<br />
of packing C is 0.25 mm when tightened.<br />
MAIN BEARING<br />
* The side clearance can also be measured as<br />
BALANCER<br />
shown in photos below. (Figs. 34 and 35)<br />
Fig. 33<br />
Fig. 34<br />
Fig. 35<br />
- 20 -
Change language