EY35, EY40 - Small Engine Discount

5-3 HOW TO DISASSEMBLE
*Length of the bolt indicates the length from the bolt head bottom surface to the threaded end.
Order
Item
Procedures
Remarks
Bolts, nuts, etc. used
1
Engine
Drain engine oil.
Drain plugs on both sides of the
case
Be careful not to lose the
the gasket.
Flange bolt
2
Fuel tank
(1) Close the strainer cock.
(2) Move the fuel pipe clamp (on
strainer side) downward.
(3) Remove the tank from tank
bracket.
8 mm (No.2) nut . . . 4 pcs.
SpI-ing washer . . .4 pcs.
3
Tank bracket
Remove tank bracket.
10 mm flange nut . . . 4 pcs.
(tightened together with
cylinder head)
4
Air cleaner
(1) Remove air cleaner cover and
element.
(2) Remove choke knob.
(3) Remove the bottom plate of
air cleaner.
Swivel
6 x 12 mm flange bolt
. . . 2 pcs.
5
Muffler cover
Remove muffler cover.
6 x 8 (5T) Flange bolt
* . . 4 pcs.
6
Muffler
(1) Remove the flange portion
of the muffler.
(2) Remove the muffler bracket.
8 mm brass nut . . . 2 pcs.
8 x 16 (ST) Bolt & washer
. . . 2 pcs., Washer . . . 1 pce
7
Carburetor
Remove the carburetor.
Be careful of the packing
etc.
Joint sheet, insulator, and
then paper packing, in ths
order from the engine side
6 mm nut . . . 2 pcs.
Spring washer . . . 2 pcs.
Washer . . . 2 pcs.
8
Governor
lever
Remove the governor lever.
Be careful of the position
of the governor spring.
6 mm special nut. . , 1 pce.
Washer . . . 1 pce.
6 x 25 (7T) bolt . . . 1 pce.
Fig. 18
- 13 -