AL-2021/2041 Operation-Manual GB - Sharp
AL-2021/2041 Operation-Manual GB - Sharp
AL-2021/2041 Operation-Manual GB - Sharp
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7 SPECI<strong>AL</strong> FUNCTIONS<br />
This chapter describes the special functions of this unit. Use these functions as<br />
needed.<br />
DESCRIPTION OF SPECI<strong>AL</strong> FUNCTIONS<br />
Toner save mode<br />
Reduces toner consumption by approximately 10%.<br />
Power save modes<br />
The unit has two power save modes of operation: preheat mode and auto power<br />
shut-off mode.<br />
Preheat mode<br />
When the unit enters the preheat mode, the power save ( ) indicator will light up<br />
and other indicators will remain on or off as before. In this condition, the fuser in<br />
the unit is maintained at a lower heat level, thereby saving power. To copy from<br />
the preheat mode, make desired copier selections and press the start ( ) key<br />
using the normal copying procedure.<br />
Auto power shut-off mode<br />
When the unit enters the auto power shut-off mode, the power save ( ) indicator<br />
will light up and other indicators will go out. The auto power shut-off mode saves<br />
more power than the preheat mode but requires a longer time before starting<br />
copying. To copy from the auto power shut-off mode, press the start ( ) key.<br />
Then make desired copier selections and press the start ( ) key using the<br />
normal copying procedure.<br />
Auto clear<br />
The unit returns to the initial settings a preset amount of time after the end of job.<br />
This preset amount of time (auto clear time) can be changed.<br />
Resolution of AUTO & MANU<strong>AL</strong> mode<br />
You can set the copy resolution used for AUTO and MANU<strong>AL</strong> ( ) exposure<br />
mode.<br />
Prevention of OC copies when the original cover/SPF is up function<br />
When enabled, this function may help prevent wasteful use of toner that occurs<br />
when the original cover/SPF is not completely closed.<br />
If the start ( ) key is pressed when the original cover/SPF is not completely closed,<br />
" " will appear in the display and copying may not take place. If copying does not<br />
take place, copying can be performed by pressing the start ( ) key again, however,<br />
the scan size set in "Copy effective paper width setting function" (program numbers<br />
25, 26) will be used.<br />
If the original cover/SPF is completely closed after " " appears, copying will take<br />
place at the normal size.<br />
7<br />
64