You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Menu operation n Page 41<br />
5 Setting the Lamp Mode<br />
This function allows you to select the usage of<br />
the two lamps installed in the projector.<br />
Selectable items<br />
Both Lamps<br />
Lamp 1 Only<br />
Lamp 2 Only<br />
Equal Use<br />
Description<br />
Both lamps are used for greater<br />
brightness.<br />
The lamp 1 is used.<br />
When the lamp 1 burns out, the<br />
lamp 2 automatically switches in<br />
use.<br />
The lamp 2 is used.<br />
When the lamp 2 burns out, the<br />
lamp 1 automatically switches in<br />
use.<br />
The lamp whose remaining life<br />
time is the longer is used.<br />
Note<br />
• For lamp protection, this function is not<br />
available for several minutes when changing<br />
the lamp mode.<br />
6 Setting the Audio<br />
You can set the following Audio items.<br />
Selectable<br />
items<br />
Volume<br />
Description<br />
You can change the volume level.<br />
The adjustable range is 0 to 60.<br />
Speaker On The audio signal is output<br />
from the internal speaker.<br />
Off The audio signal is not output<br />
from the internal speaker.<br />
Note<br />
• The audio signal is not output from the speaker<br />
of the projector when the audio cable is<br />
connected to the audio output terminal and you<br />
cannot change the setting.<br />
Using the Ex. Setting<br />
Select “Ex. Setting” and then press (ENTER)<br />
to set “Fan Mode”, “STANDBY Mode”, “STANDBY<br />
Audio Out”, “Filter Message”, “3D MODE”, “LAN/<br />
RS232C” or “Network”.<br />
8 Fan Mode Setting<br />
This function changes the fan rotation speed.<br />
Selectable<br />
items<br />
Normal<br />
High<br />
Description<br />
Suitable for normal environments.<br />
Set when using the projector at<br />
altitudes of approximately 1,200 meters<br />
(4,000 feet) or more.<br />
When “Fan Mode” is set to “High”, the fan rotation<br />
speeds up, and the fan noise becomes louder.<br />
9 STANDBY Mode<br />
When set to “Eco”, power consumption is<br />
reduced in Standby mode.<br />
Selectable<br />
items<br />
Standard<br />
Eco<br />
Description<br />
The monitor output, LAN/RS232C and<br />
Network functions are activated even if<br />
the projector is in Standby mode.<br />
The monitor output, LAN/RS232C and<br />
Network functions are switched off in<br />
Standby mode.<br />
0 STANDBY Audio Out<br />
You can set audio output from the AUDIO<br />
OUTPUT terminal of the projector that is in<br />
Standby mode.<br />
Selectable<br />
items<br />
On<br />
Off<br />
Description<br />
The audio signal is output from the<br />
AUDIO OUTPUT terminal in Standby<br />
mode.<br />
The audio signal is not output from the<br />
AUDIO OUTPUT terminal in Standby<br />
mode.<br />
Note<br />
• When “Eco” is selected for “STANDBY Mode”,<br />
“STANDBY Audio Out” is set to “Off”<br />
automatically and you cannot change the<br />
setting.<br />
Useful<br />
Features<br />
53
Change language