You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
INPUT button<br />
(ENTER) button<br />
P/R buttons<br />
Adjusting the Volume<br />
Press VOL +/– on the remote control<br />
to adjust the volume.<br />
On-screen display<br />
Volume 1<br />
Switching the Input Mode<br />
Select the appropriate Input mode for the<br />
connected equipment.<br />
Press INPUT on the projector or on<br />
the remote control to display the<br />
INPUT list.<br />
INPUT list<br />
INPUT<br />
DVI-D<br />
COMPUTER1<br />
COMPUTER2<br />
COMPONENT<br />
S-VIDEO<br />
VIDEO<br />
VOL +/– (Volume)<br />
buttons<br />
AV MUTE button<br />
• While the INPUT list is displayed, follow the<br />
procedure below to switch the input mode.<br />
– Press P/R to select the desired input mode<br />
and then press (ENTER).<br />
• If (ENTER) is not pressed, the projector<br />
switches to the selected input mode in a<br />
few seconds.<br />
Note<br />
• When no signal or non-supported signal is<br />
received, “NO SIGNAL” will be displayed.<br />
Note<br />
• Pressing VOL– will lower the volume.<br />
• Pressing VOL+ will raise the volume.<br />
• When the projector is connected to external<br />
equipment, the volume level of the external<br />
equipment changes in accordance with the<br />
volume level of the projector. Set the projector's<br />
volume to the lowest level when turning the<br />
projector on/off or when changing the input<br />
signal.<br />
• When you do not want to output the sound<br />
from the projector's speaker while the<br />
projector is connected to external equipment,<br />
set “Speaker” in “Audio” of the “PRJ-ADJ”<br />
menu to “Off”. (See page 53.)<br />
• The audio signal is not output from the internal<br />
speaker when connecting the audio cable to<br />
the MONITOR OUT (AUDIO) terminal.<br />
Displaying the Black Screen<br />
and Turning Off the Sound<br />
Temporarily<br />
Press AV MUTE on the remote control<br />
to temporarily display a black screen<br />
and turn off the sound.<br />
On-screen display<br />
AV MUTE<br />
Note<br />
• Pressing AV MUTE again will turn the<br />
projected image back on.<br />
Basic<br />
<strong>Operation</strong><br />
33