Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Turning the Projector On/Off<br />
Turning the Projector On<br />
Note that the connections to external<br />
equipment and power outlet should be<br />
done before performing the operations<br />
written below. (See pages 21 to 25.)<br />
Remove the lens cap. Then switch the<br />
MAIN POWER switch on the projector<br />
to “ON” and, after the POWER<br />
indicator has turned red, press<br />
STANDBY/ON on the projector or on<br />
the remote control.<br />
• The POWER indicator illuminates green.<br />
• After the LAMP indicator illuminates, the projector<br />
is ready to start operation.<br />
Note<br />
• About the LAMP Indicator<br />
The LAMP indicator illuminates to indicate the<br />
status of the lamp. (See page 64 for details.)<br />
Green or orange: The lamp is on.<br />
Blinking in green or orange: The lamp is<br />
warming up.<br />
Red: The lamp is shut down abnormally<br />
or the lamp should be replaced.<br />
• When you switch on the projector, a slight<br />
fl ickering of the image may be experienced<br />
within the fi rst minute after the lamp has been<br />
illuminated. This is normal operation as the<br />
lamp's control circuitry is stabilizing the lamp<br />
output characteristics. It should not be<br />
regarded as faulty operation.<br />
• If the projector is put into Standby mode and<br />
immediately turned on again, the lamp may<br />
take some time to start projection.<br />
• When Security Lock is set, the password<br />
input box appears. To cancel the password<br />
setting, input the password that you have<br />
already set. See page 51 for details.<br />
Turning the Power Off (Putting<br />
the Projector into Standby Mode)<br />
Press STANDBY/ON on the projector or<br />
on the remote control, then press that<br />
button again while the confirmation<br />
message is displayed, to put the<br />
projector into Standby mode.<br />
• The projector cannot be turned on while cooling.<br />
Info<br />
• When “Auto Restart” is set to “On”:<br />
If the power cord is unplugged from the outlet<br />
or the breaker switch is turned off when the<br />
projector is on, then the projector<br />
automatically turns on when the power cord<br />
is plugged into the AC outlet or the breaker<br />
switch is turned on. (See page 52.)<br />
• English is the factory default language. If you<br />
want to change the on-screen display to<br />
another language, change the language<br />
according to the procedure on page 49.<br />
STANDBY/ON button<br />
LAMP 1 indicator<br />
LAMP 2 indicator<br />
POWER indicator<br />
STANDBY/ON<br />
button<br />
On-screen display (confirmation message)<br />
Enter STANDBY Mode?<br />
Yes : Press Again<br />
No : Please Wait<br />
Info<br />
Direct Power Off function:<br />
• You can unplug the power cord or switch the<br />
MAIN POWER switch to “OFF” even if the<br />
cooling fan is still running.<br />
• If you turn the power back on in the cases<br />
shown below, the lamp will take a longer<br />
time to light up than usual:<br />
– When the power cord is unplugged during<br />
operation<br />
– When the MAIN POWER switch is turned<br />
“OFF” during operation<br />
28