Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Controlling the Projector by a Computer<br />
When the RS-232C terminal on the projector is connected to the RS-232C serial terminal on the<br />
computer, or when the LAN terminal on the projector is connected to the LAN terminal on the<br />
computer, the computer can be used to control the projector. Refer to the “SETUP MANUAL”<br />
contained on the supplied CD-ROM for details.<br />
When connecting to a computer using an RS-232C serial control cable<br />
Computer<br />
Side view<br />
To RS-232C terminal<br />
To RS-232C terminal<br />
RS-232C serial control cable<br />
(cross type, commercially available)<br />
Note<br />
• When you establish the connection shown above, set “LAN/RS232C” in “Ex. Setting” of the “PRJ-<br />
ADJ” menu to “RS232C”.<br />
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the<br />
operation manual of the computer for details.<br />
• Refer to “SETUP MANUAL” contained on the supplied CD-ROM for the RS-232C<br />
specifications and commands.<br />
Info<br />
• Do not connect the RS-232C cable to a terminal other than the RS-232C terminal on the computer.<br />
This may damage your computer or projector.<br />
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on.<br />
This may damage your computer.<br />
24
Change language