XG-PH80W-N/X-N Operation-Manual GB

More documents

Recommendations

Info

IMPORTANT • For your assistance in reporting the loss or theft of your Projector, please record the Model and Serial Number located on the bottom of the projector and retain this information. • Before recycling the packag ing, please ensure that you have checked the contents of the carton thoroughly against the list of “Supplied accessories” on page 11. Model No.: Serial No.: ii
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fi tted with a non-rewireable (moulded) plug incorporating a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refi t the fuse cover after replacing the fuse. Never use the plug without the fuse cover fi tted. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the mains plug and fi t an appropriate type. DANGER: The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet, as a serious electric shock may occur. To fi t an appropriate plug to the mains lead, follow the instructions below: WARNING: THIS APPARATUS MUST BE EARTHED. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Green-and-yellow : Earth Blue : Neutral Brown : Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured green or green-and-yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN. Authorized representative responsible for the European Union Community Market SHARP ELECTRONICS (Europe) GmbH Sonninstraße 3, D-20097 Hamburg E.U. ONLY iii
Page 1: DATA PROJECTOR MODEL XG-PH80W-N XG-
Page 5 and 6: Before using the projector, please
Page 7 and 8: How to Read this Operation Manual
Page 9 and 10: Adjusting the Projector Function (
Page 11 and 12: 15. Overloading Do not overload wal
Page 13 and 14: Caution regarding usage of the proj
Page 15 and 16: Accessories Supplied accessories In
Page 17 and 18: Part Names and Functions Numbers in
Page 19 and 20: Numbers in Z refer to the main page
Page 21 and 22: Easy Start This section shows the b
Page 23 and 24: Setting Up the Projector Video Setu
Page 25 and 26: Connecting the Projector to Other E
Page 27 and 28: Equipment Video equipment, Camera,
Page 29 and 30: When connecting to the LAN terminal
Page 31 and 32: 5 Insert the replacement lens with
Page 33 and 34: Image Projection Shifting the Lens
Page 35 and 36: Adjusting the Focus Press FOCUS +/-
Page 37 and 38: INPUT button (ENTER) button P/R but
Page 39 and 40: Basic Operation RESIZE Output scree
Page 41 and 42: Using the Remote Control to Operate
Page 43 and 44: Useful Features “Signal adjustmen
Page 45 and 46: Using the Menu Screen Adjustment bu
Page 47 and 48: Picture Adjustment (“Picture” M
Page 49 and 50: Menu operation n Page 41 7 Adjustin
Page 51 and 52: Video Adjustment (“Video” Menu)
Page 53 and 54:
Adjusting the Projected Image (“S
Page 55 and 56:
Menu operation n Page 41 9 Security
Page 57 and 58:
Menu operation n Page 41 5 Setting
Page 59 and 60:
Useful Features Returning to the De
Page 61 and 62:
Useful Features WARNING ■ The fol
Page 63 and 64:
Using 3D Viewing Mode Use the follo
Page 65 and 66:
Maintenance Cleaning the projector
Page 67 and 68:
2 Remove the filter covers. • Rem
Page 69 and 70:
TEMP. (temperature warning)/ STATUS
Page 71 and 72:
Removing and Installing the Lamp Un
Page 73 and 74:
Replacing the Color Wheel The proje
Page 75 and 76:
Compatibility Chart Computer • Mu
Page 77 and 78:
Troubleshooting Problem Check Page
Page 79 and 80:
Problem Check Page 3D images fl ick
Page 81 and 82:
Specifications Model XG-PH80W-N XG-
Page 83:
Index 4:3·············
show all

XG-PH80W-N/X-N Operation-Manual GB

Create successful ePaper yourself

Delete template?

Save as template?