Toxic Chemical Release Inventory Reporting Forms and Instructions

More documents

Recommendations

Info

Instructions for Completing Part II of EPA Form R Figure 4 Hypothetical Secton 6.2 Completed for Two Off-Site Locations This off-site location receives a transfer of 15,000 pounds of toluene and will combust 5,000 pounds for the purposes of energy recovery, enter 7,500 pounds into a recovery process, and dispose of the remaining 2,500 pounds. This off-site location receives a transfer of 12,500 pounds of tetrachloroethylene (perchloroethylene) that is part of a waste that is combusted for the purposes of energy recovery in an industrial furnace. Note that the tetrachloroethylene should be reported using code M54 to indicate that it is combusted in an energy recovery unit but it does not contribute to the heating value of the waste. 52 Toxics Release Inventory Reporting Forms and Instructions
Instructions for Completing Part II of EPA Form R Section 7. On-Site Waste Treatment, Energy Recovery, and Recycling Methods You must report in this section the methods of waste treatment, energy recovery, and recycling applied to the reported EPCRA section 313 chemical in wastes on-site. There are three separate sections for reporting such activities. Section 7A On-Site Waste Treatment Methods and Efficiency Most of the chemical-specific information required by EPCRA section 313 that is reported on Form R is specific to the EPCRA section 313 chemical rather than the waste stream containing the EPCRA section 313 chemical. However, EPCRA section 313 does require that waste treatment methods applied on-site to waste streams that contain the EPCRA section 313 chemical be reported. This information is reportable regardless of whether the facility actively applies treatment or the treatment of the waste stream occurs passively. This information is collected in Section 7A of Form R. In Section 7A, you must provide the following information if you treat waste streams containing the reported EPCRA section 313 chemical on-site: (a) The general waste stream types containing the EPCRA section 313 chemical being reported; (b) The waste treatment method(s) or sequence used on all waste streams containing the EPCRA section 313 chemical; (c) The range of concentration of the EPCRA section 313 chemicals in the influent to the waste treatment method; (d) The efficiency of each waste treatment method or waste treatment sequence in destroying or removing the EPCRA section 313 chemical; and (e) Whether the waste treatment efficiency figure was based on actual operating data. Use a separate line in Section 7A for each general waste stream type. Report only information about treatment of waste streams at your facility, not information about off-site waste treatment. If you do not perform on-site treatment of waste streams containing the reported EPCRA section 313 chemical, check the NA box at the top of Section 7A. 7A Column a: General Waste Stream For each waste treatment method, indicate the type of waste stream containing the EPCRA section 313 chemical that is treated. Enter the letter code that corresponds to the general waste stream type: A W L S Gaseous (gases, vapors, airborne particulates) Wastewater (aqueous waste) Liquid waste streams (non-aqueous waste) Solid waste streams (including sludges and slurries) If a waste is a combination of water and organic liquid and the organic content is less than 50%, report it as a wastewater (W). Slurries and sludges containing water should be reported as solid waste if they contain appreciable amounts of dissolved solids, or solids that may settle, such that the viscosity or density of the waste is considerably different from that of process wastewater. 7A Column b: Waste Treatment Method(s) Sequence Enter the appropriate waste treatment code from the list below for each on-site waste treatment method used on a waste stream containing the EPCRA section 313 chemical, regardless of whether the waste treatment method actually removes the specific EPCRA section 313 chemical being reported. Waste treatment methods must be reported for each type of waste stream being treated (i.e., gaseous waste streams, aqueous waste streams, liquid non-aqueous waste streams, and solids). Except for the air emission treatment codes, the waste treatment codes are not restricted to any medium. Waste streams containing the EPCRA section 313 chemical may have a single source or may be aggregates of many sources. For example, process water from several pieces of equipment at your facility may be combined prior to waste treatment. Report waste treatment methods that apply to the aggregate waste stream, as well as waste treatment methods that apply to individual waste streams. If your facility treats various wastewater streams containing the EPCRA section 313 chemical in different ways, the different waste treatment methods must be listed separately. If your facility has several pieces of equipment performing a similar service in a waste treatment sequence, you may combine the reporting for such equipment. It is not necessary to enter four codes to cover four scrubber units, for example, if all four are treating waste streams of similar character (e.g., sulfuric acid mist emissions), have similar influent concentrations, and have similar removal efficiencies. If, however, any of these parameters differs from one unit to the next, each scrubber should be listed separately. If you are using the hardcopy paper form, and if your facility performs more than eight sequential waste treatment methods on a single general waste stream, continue listing the methods in the next row and renumber appropriately those waste treatment method code boxes you used to continue the sequence. For example, if the general waste stream in box 7A.1a had nine treatment methods applied to it, the ninth method would be indicated in the first method box for row Toxics Release Inventory Reporting Forms and Instructions 53
Page 1 and 2:
Toxic Chemical Release Inventory Re
Page 3 and 4:
Toxic Chemical Release Inventory Re
Page 5 and 6:
More Information or Assistance TRI
Page 7 and 8:
Important Information for Reporting
Page 9 and 10:
Toxics Release Inventory Reporting
Page 11 and 12:
Toxics Release Inventory Reporting
Page 13 and 14:
TRI Reporting Software Toxics Relea
Page 15 and 16:
Chemical and Industry Guidance Docu
Page 17 and 18:
III. Industry-Specific Guidance EPA
Page 19 and 20:
Form Approved OMB Number: 2070-0093
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
(IMPORTANT: Type or print; read ins
Page 31 and 32:
IMPORTANT: Type or print; read inst
Page 33 and 34: A. General Information Reporting to
Page 35 and 36: General Information may request doc
Page 37 and 38: General Information < Use for motor
Page 39 and 40: General Information A.8 How to Obta
Page 41 and 42: B. Facility Eligibility Determinati
Page 43 and 44: Facility Eligibility Determination
Page 63 and 64: C. Instructions for Completing EPA
Page 65 and 66: Instructions for Completing Part I
Page 67 and 68: Part II. Chemical Specific Informat
Page 69 and 70: Instructions for Completing Part II
Page 81 and 82: Example 14: Container Residue Instr
Page 83: Instructions for Completing Part II
Page 101 and 102: D. Facility Eligibility Determinati
Page 103 and 104: E. Instructions for Completing EPA
Page 105 and 106: Instructions for Completing Part I
Page 107 and 108: Section 2. Mixture Component Identi
Page 109 and 110: Table I. SIC codes 10 Metal Mining
Page 111 and 112: Table I 2542 Office and store fixtu
Page 113 and 114: Table I 3431 Enameled iron and meta
Page 115 and 116: Table I 3873 Watches, clocks, clock
Page 117 and 118: Table II. EPCRA Section 313 Chemica
Page 119 and 120: Table II quantities. Phosphorus (ye
Page 121 and 122: Table II De Minimis CAS Number Chem
Page 135 and 136:
Table II De Minimis CAS Number Chem
Page 137 and 138:
Table II De Minimis CAS Number Chem
Page 139 and 140:
Table II N171 Ethylenebisdithiocarb
Page 141 and 142:
Table III. State Abbreviations Alab
Page 143 and 144:
Table IV. Federal Information Proce
Page 145 and 146:
Table IV YI YM ZA ZI Yugoslavia Yem
Page 147 and 148:
Appendix A. Federal Facility Report
Page 149 and 150:
Appendix A More Help is Available!
Page 151 and 152:
Appendix B. Reporting Codes For EPA
Page 153 and 154:
Appendix B F99 Other Incineration/T
Page 155 and 156:
Appendix B Reporting the Waste Mana
Page 157 and 158:
Appendix B Section 7B. On-site Ener
Page 159 and 160:
Appendix C. Facility Data Profiles
Page 161 and 162:
Appendix C C. Common Errors in Comp
Page 163 and 164:
Appendix C ” Generic chemical nam
Page 165 and 166:
Appendix C ” Any time a reported
Page 167 and 168:
Appendix C ” M95 Transfer to Wast
Page 169 and 170:
Appendix C 25. EPA has corrected th
Page 171 and 172:
Appendix C one of the activity(ies)
Page 173 and 174:
Appendix C 89. You reported a negat
Page 175 and 176:
Appendix D. Supplier Notification R
Page 177 and 178:
Appendix D “ 0.1 percent if the E
Page 179 and 180:
Appendix D Sample Notification Lett
Page 181 and 182:
Appendix E. How To Determine Latitu
Page 183 and 184:
Appendix E (5) To determine the inc
Page 185 and 186:
Appendix F. State Designated Sectio
Page 187 and 188:
Appendix F Illinois Ms. Deirdre McQ
Page 189 and 190:
Appendix F New Hampshire Ms. Wallen
Page 191 and 192:
Appendix F Texas U.S. Postal Servic
Page 193 and 194:
Appendix G. Section 313 EPA Regiona
Page 195 and 196:
Appendix H. Other Relevant Section
Page 197 and 198:
Appendix I. Sample Revision and Wit
Page 199 and 200:
Index A Activity Exemptions 15 Acti
Page 201:
United States Environmental Protect
show all

Toxic Chemical Release Inventory Reporting Forms and Instructions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?