Owner's Manual Cadillac BLS - IFS Europe BV

460_OM_MY09.book Page 99 Wednesday, April 2, 2008 10:32 AM
Interior equipment
99
Button for temporary deactivation of rear
door window switches and temporary
override of window pinch protection
Overriding the pinch protection
WARNING
Make sure nothing obstructs the window
when it is closed without pinch protection.
If dirt, ice or similar create so much resistance
that the pinch protection engages in
the front electric windows (the window
cannot be closed), the pinch protection can
be temporarily disengaged and the window
closed.
1 Make sure the ignition is in position 3.
2 Press and hold the button on the
driver’s door while operating the window
in question.
3 Close the window in question.
The pinch protection will be active the next
time a window is operated.
Calibration
WARNING
The pinch protection will not be engaged
after a power break until the electric windows
have been calibrated.
The front electric windows should be calibrated
if automatic closing does not work or
if the battery has been disconnected. The
pinch protection will not work if the windows
are not calibrated 3.
Calibration is performed as follows:
1 Close the doors.
2 The car must be running at idling speed.
The battery charger must not be connected
to the car’s battery during calibration.
3 Open the window fully, the button must
be kept depressed the whole time.
4 Close the window fully, the button must
be kept raised the whole time and for
approx. 1 second after the window has
closed.
5 Open the window fully, the button must
be kept depressed the whole time and
for approx. 1 second after the window
has fully opened.
6 Close the window fully, and keep the
button raised until the calibration is
confirmed with a "chime".
Repeat steps 3-6 for the windows which
require calibration.