Owner's Manual Cadillac BLS - IFS Europe BV
Share Embed Flag
Download ePaper

Owner's Manual Cadillac BLS - IFS Europe BV

Owner's Manual Cadillac BLS - IFS Europe BV Owner's Manual Cadillac BLS - IFS Europe BV

ifseurope.eu
from ifseurope.eu More from this publisher
02.07.2014 Views

460_OM_MY09.book Page 92 Wednesday, April 2, 2008 10:32 AM Instruments and controls 92 Initial settings in cold weather To start with, the system will automatically select the defroster setting, maximum heat and low fan speed. As the engine warms up, air will also be distributed through the floor vents and the fan speed will be increased. As the temperature inside the car nears the selected value, both the fan speed and the heat will be decreased to a level determined by the system. Panel Initial settings in hot weather The system will automatically distribute air through the panel vents at high fan speed and will activate the A/C compressor (unless the AC ON switch has been pressed). If the ambient air temperature is over 25 °C, the recirculation cuts in after 0-15 seconds, if this is required in order to reach the desired temperature. As the temperature inside the car nears the selected value, the fan speed will be decreased to a value determined by the system. Defroster-floor-panel

460_OM_MY09.book Page 93 Wednesday, April 2, 2008 10:32 AM Formation of ice and mist in extreme weather conditions It is only in the most extreme conditions that icing and misting of window glass are likely to be a problem, such as in torrential rain or severe cold coupled with high relative humidity, or when passengers are perspiring heavily or wearing wet clothes. The following measures are recommended if such problems should occur: 1 Select AUTO and set the temperature to 21 °C. 2 Select . If this is not enough ... 3 Increase the fan speed. If this is not enough ... 4 Select a higher temperature. Electric heating, front seats 3 The seat cushions and backrests of the front seats are heated. Heating is thermostatically controlled. Heating has two settings. Instruments and controls 93 Calibration The ACC system is calibrated automatically every 40th start (if the ignition has been off for more than 2 hours) or if the battery has been disconnected. The system can be calibrated manually by pressing the AUTO button and recirculation button simultaneously. For instructions regarding using and programming the Park Heater and Block Heater, refer to page 252.

460_OM_MY09.book Page 92 Wednesday, April 2, 2008 10:32 AM<br />

Instruments and controls<br />

92<br />

Initial settings in cold weather<br />

To start with, the system will automatically select the defroster setting,<br />

maximum heat and low fan speed.<br />

As the engine warms up, air will also be distributed through the floor<br />

vents and the fan speed will be increased.<br />

As the temperature inside the car nears the selected value, both the<br />

fan speed and the heat will be decreased to a level determined by<br />

the system.<br />

Panel<br />

Initial settings in hot weather<br />

The system will automatically distribute air through the panel vents<br />

at high fan speed and will activate the A/C compressor (unless the<br />

AC ON switch has been pressed).<br />

If the ambient air temperature is over 25 °C, the recirculation cuts in<br />

after 0-15 seconds, if this is required in order to reach the desired<br />

temperature.<br />

As the temperature inside the car nears the selected value, the fan<br />

speed will be decreased to a value determined by the system.<br />

Defroster-floor-panel

logo

products

Resources

Company

Terms of service
Privacy policy
Cookie policy
Cookie settings
Imprint
Change language
Made with love in Switzerland
© 2024 Yumpu.com all rights reserved

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!