Owner's Manual Cadillac BLS - IFS Europe BV
Owner's Manual Cadillac BLS - IFS Europe BV
Owner's Manual Cadillac BLS - IFS Europe BV
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
460_OM_MY09.book Page 89 Wednesday, April 2, 2008 10:32 AM<br />
Temperature control<br />
The cabin is divided into two temperature<br />
zones:<br />
• Driver’s zone;<br />
• Passenger zone (front and rear seats).<br />
The temperature can be controlled within<br />
the interval 16 and 26 °C.<br />
The selected temperature is not the actual<br />
air temperature, but corresponds to the<br />
comfort level normally experienced at that<br />
temperature after allowance has been<br />
made for the air flow, relative humidity, solar<br />
radiation, etc., currently prevailing inside<br />
the car.<br />
• The most usual temperature setting<br />
is 18–24 °C, depending on personal<br />
preference and what clothing is worn.<br />
• It is recommended that changes in the<br />
temperature setting be made in steps<br />
of 1 °C.<br />
Once the desired climate has been<br />
achieved, the rear centre vents can be<br />
closed to prevent warm air being distributed<br />
at face height.<br />
When the ignition is switched off, only the<br />
temperature control affects the system the<br />
next time the engine is started. The system<br />
will warm up/cool down to the temperature<br />
to which the control is set.<br />
Instruments and controls<br />
89<br />
MAX heating (red indicator)<br />
The MAX heating setting is obtained by<br />
turning the temperature control to the first<br />
position past 26 (to the red LED). The<br />
driver’s side selection regulates air distribution<br />
and recirculation status. Temperature,<br />
however, can be adjusted on the passenger<br />
side.<br />
Settings when MAX heating is selected:<br />
• Maximum heat.<br />
• Air distribution to windscreen and floor.<br />
• Recirculation OFF.<br />
• High fan speed.<br />
MAX cooling (blue indicator)<br />
The MAX cooling setting is obtained by turning<br />
the temperature control to the first position<br />
past 16 (to the blue LED). The driver’s<br />
side selection regulates air distribution and<br />
recirculation status. Temperature, however,<br />
can be adjusted on the passenger side.<br />
Settings when MAX cooling is selected:<br />
• Max. cooling effect (A/C compressor will<br />
run even if AC OFF has been selected).<br />
• Air distribution through panel vents.<br />
• Maximum fan speed.<br />
• Recirculation ON.