Owner's Manual Cadillac BLS - IFS Europe BV

460_OM_MY09.book Page 53 Wednesday, April 2, 2008 10:32 AM
Locks and car alarm
53
Press the emblem to remove the
traditional key.
1 Press the emblem on the reverse of the
remote control to remove the traditional
key.
2 Insert the tip of the key into the small
hole and turn the key to split the remote
control.
3 Change the battery. Insert it in same way
as the old battery, with the positive (+)
side facing down.
4 Fit and press together the two halves of
the remote control until you hear several
clicks. Avoid pressing the buttons. Reinsert
the traditional key into the remote
control.
5 After changing the battery in the remote
control, it is only possible to use the
remote control a limited number of times
before synchronisation with the car is
lost. Therefore, do not press the buttons
on the remote control repeatedly directly
after changing the battery.
Unlock the car and insert the remote
control into the ignition switch to synchronise
the remote control and car.
If the central locking system does not work
after changing the battery and the car is
locked, proceed as follows:
1 Unlock the front left door with the traditional
key. If the car has a car alarm, this
will be tripped.
2 Open the door and insert the remote
control into the ignition switch. If the car
has a car alarm, this will be silenced.
The remote control and receiver unit are
now synchronised.
Change the battery and fit together to two
halves of the remote control