02.07.2014 Views

Owner's Manual Cadillac BLS - IFS Europe BV

Owner's Manual Cadillac BLS - IFS Europe BV

Owner's Manual Cadillac BLS - IFS Europe BV

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

460_OM_MY09.book Page 253 Wednesday, April 2, 2008 10:32 AM<br />

Technical data<br />

253<br />

interrupted automatically when the engine<br />

is started.<br />

Park Heater 3 and Block Heater 3<br />

If the car has an electric or fuel driven<br />

engine heater, the start times are<br />

controlled in Settings under the headings<br />

Block Heater/Park Heater.<br />

Make the settings within 3 minutes after the<br />

engine has been switched off and the<br />

remote control removed from the ignition<br />

switch. During setting the time is extended<br />

in increments of 30 seconds, if 3 minutes<br />

are exceeded. Otherwise the remote control<br />

must be inserted into the ignition switch and<br />

turned to the ON position until the<br />

text "Checking" disappears. Then the<br />

remote control can be turned back,<br />

removed and the process restarted.<br />

1Select Settings using the steering<br />

wheel buttons or .<br />

2 Hold the SET button depressed until a<br />

chime sounds.<br />

3Select Block Heater or Park Heater.<br />

4 Go back/modify using the CLR button.<br />

To now start the heater, MANUAL START<br />

( heater is switched off)<br />

1 Press the SET button.<br />

2Select MANUAL START.<br />

3 End by pressing the SET button.<br />

Go back/modify using the CLR button.<br />

To select the start time, TIMER A, B or C<br />

(heater is switched off)<br />

1 Press the SET button.<br />

2Select TIMER A, B or C using the<br />

steering wheel buttons.<br />

3 Press the SET button. The heater’s start<br />

time can now be adjusted using the<br />

steering wheel buttons. Then press the<br />

SET button, START and the selected<br />

start time is displayed.<br />

4 End by pressing the SET button.<br />

Go back/modify using the CLR button.<br />

To switch off the heater when it is running<br />

1 Press the SET button.<br />

2Select OFF.<br />

3 End by pressing the SET button.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!