Table of Contents Cadillac Escalade - IFS Europe BV

Table of Contents Cadillac Escalade - IFS Europe BV Table of Contents Cadillac Escalade - IFS Europe BV

02.07.2014 Views

AKENG44_Escalade Page 230 Wednesday, July 16, 2008 12:22 PM Starting and Operating Instructions You can program up to ten additional keys with the two original keys present. To program an additional key: 1. Verify that the new key has stamped on it. 2. Start the engine using the previously programmed master key. If the engine does not start, see your dealer for service. 3. Repeat the previous step using the other master key. 4. Turn off the ignition and remove the key. 5. Within five seconds, insert the key that you are programming and turn it to ON. Once the key is programmed, the Security System Light will turn off. The key may be programmed so quickly that you may not even realize that the Security System Light had turned on. 6. If additional keys are to be programmed, repeat the previous steps. If all of your ignition keys are lost or damaged, see your dealer or a locksmith who can service Pass-Key ® III Plus systems to make and program a new key. ■ THEFT DETERRENT SYSTEM Your vehicle is equipped with a Theft Deterrent System. To arm the system: 1. Open the door. 2. Lock the vehicle with the remote keyless entry system or the power door lock switch. The security system light will begin flashing to indicate that the theft deterrent system is arming. . . . 230

AKENG44_Escalade Page 231 Wednesday, July 16, 2008 12:22 PM Section 3 3. Close all doors. The Security System Light will turn off after about 30 seconds. When the light turns off, the system is armed. The system will not arm if you lock the doors with a key or the manual lock lever. To disarm the system, unlock the vehicle using the Remote Keyless Entry system. If a door, the liftgate or the hood is opened in any other way, the alarm will go off. First, a pre-alarm will sound for 10 seconds. The horn will chirp and the lights will flash. Then the full alarm will sound. The horn will sound and the headlights will flash for up to two minutes. The alarm will then turn off to preserve battery power. To avoid triggering the alarm, you must unlock a door with the Keyless Entry system. If the alarm is set off by accident, you can shut it off by pressing the unlock button on the remote keyless entry transmitter or by starting the vehicle. To test the system, lock the doors using the remote keyless entry transmitter from inside the vehicle. Wait for the Security System Light to turn off. Then, unlock the door using the manual lock lever. Open the door. The pre-alarm should sound. Wait ten seconds for the full alarm to activate. To turn the alarm off, press the unlock button on the keyless entry transmitter or start the engine. If the horn does not work, the horn fuse may be blown. If the problem is fuse-related, see "Fuses and Circuit Breakers" in Section 4 for additional information. If the alarm still does not sound or the headlights do not flash, see your dealer for service. Note: The power door lock switch will not work to unlock the vehicle when the theft deterrent system is armed. – – – 231 . . .

AKENG44_<strong>Escalade</strong> Page 231 Wednesday, July 16, 2008 12:22 PM<br />

Section 3<br />

3. Close all doors.<br />

The Security System Light<br />

will turn <strong>of</strong>f after about<br />

30 seconds.<br />

When the light turns <strong>of</strong>f, the<br />

system is armed.<br />

The system will not arm if you lock<br />

the doors with a key or the manual<br />

lock lever.<br />

To disarm the system, unlock the<br />

vehicle using the Remote Keyless<br />

Entry system. If a door, the liftgate<br />

or the hood is opened in any other<br />

way, the alarm will go <strong>of</strong>f.<br />

First, a pre-alarm will sound for<br />

10 seconds. The horn will chirp<br />

and the lights will flash. Then the<br />

full alarm will sound.<br />

The horn will sound and the<br />

headlights will flash for up to<br />

two minutes.<br />

The alarm will then turn <strong>of</strong>f to<br />

preserve battery power.<br />

To avoid triggering the alarm, you<br />

must unlock a door with the<br />

Keyless Entry system.<br />

If the alarm is set <strong>of</strong>f by accident,<br />

you can shut it <strong>of</strong>f by pressing the<br />

unlock button on the remote<br />

keyless entry transmitter or by<br />

starting the vehicle.<br />

To test the system, lock the doors<br />

using the remote keyless entry<br />

transmitter from inside the vehicle.<br />

Wait for the Security System Light<br />

to turn <strong>of</strong>f. Then, unlock the door<br />

using the manual lock lever. Open<br />

the door.<br />

The pre-alarm should sound.<br />

Wait ten seconds for the full alarm<br />

to activate.<br />

To turn the alarm <strong>of</strong>f, press the<br />

unlock button on the keyless entry<br />

transmitter or start the engine.<br />

If the horn does not work, the horn<br />

fuse may be blown.<br />

If the problem is fuse-related,<br />

see "Fuses and Circuit Breakers"<br />

in Section 4 for additional<br />

information.<br />

If the alarm still does not sound or<br />

the headlights do not flash, see<br />

your dealer for service.<br />

Note: The power door lock switch<br />

will not work to unlock the vehicle<br />

when the theft deterrent system is<br />

armed.<br />

–<br />

–<br />

–<br />

231 . . .

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!