Table of Contents Cadillac Escalade - IFS Europe BV

AKENG44_Escalade Page 116 Wednesday, July 16, 2008 12:22 PM
Instrumentation and Controls
You may be able to flash your high
beams to signal other drivers.
To do this, pull the multifunction
lever toward you.
Then release the lever.
High-Low Beam Control
When the headlights are turned on
and the lever is in the center
position, the headlights are set to
low beams.
To change the lights from low
beams to high beams, push the
lever toward the front of the
vehicle. To change the lights back
to low beams, pull the lever back
toward you. When the high beams
are on, an indicator light on the
instrument cluster will also be on.
Windshield Wipers
NOTICE
Clear any ice or snow from the
wiper blades before using them
to prevent damage to the
blades and overloading the
wiper motor.
Rotate the band to turn on the
wipers.
For a single wiping cycle, rotate
the band to the "mist" setting .
. . . 116