Table of Contents Cadillac Escalade - IFS Europe BV

AKENG44_Escalade Page 115 Wednesday, July 16, 2008 12:22 PM
Section 1
The turn signal arrows on the
instrument cluster will not flash
faster when a side repeater light
is burned out. Check the side
repeater lights periodically to
make sure they are working
properly.
If a bulb is burned out, replace it to
help avoid an accident. If the
green arrows don't go on at all
when you signal a turn, check the
fuse and for burned-out bulbs.
See "Fuses and Circuit Breakers" in
Section 4 for additional information.
If a turn signal is left on for more
than 1.2 km, a chime will sound
and the TURN SIGNAL ON
message will appear on the Driver
Information Center display to
remind you to turn it off. If you
need it on longer, turn the signal
off, then back on.
■ MULTIFUNCTION
LEVER
Turn Signal
To signal a turn, move the lever all
the way up (right) or down (left).
When the turn is over, the lever
will return automatically. To signal
a lane change, press the lever for
less than one second and the turn
signal will automatically flash three
times. If more flashes are desired,
hold it there until you complete
your lane change. An arrow on the
instrument cluster will flash in the
direction of the turn or lane
change.
If Tow/Haul Mode is activated
when you signal a lane change,
the turn signal lights will flash six
times.
Your vehicle is equipped with side
repeater lights.
The side repeater lights come on
whenever the turn signal lights are
on.
If the arrows flash at a faster rate
than normal, a signal bulb may be
burned out. Check the front and
rear signal lights to make sure they
are working properly.
–
115 . . .