PRT CTRL Integrated Controller Reference Manual

RD001 R1 Key Md
None
Use the [1] and [3] keys to scroll the available keypad mode settings. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
Keypad Mode
Operation
There is no keypad device connected to or associated with
None
this reader input device.
An LCD keypad is used for PIN entry. PIN entry is only
possible with the Card and PIN configuration when using an
LCD Keypad
LCD Keypad. To unlock in the PIN Only or Card or PIN
modes the unlock shortcut key can be used. The LCD
Keypad Address is configured in the next screen.
A 26 Bit Wiegand Keypad is connected in parallel with the
26 Bit (Site 0)
Reader Device and has a site code of 0 set for the unit.
A Motorola® Format the ARK-501 outputs 8 bits of data for
each key that is pressed consisting of the first 4 bits being
ARK-501
inverted from the remaining 4. This format requires the
user to press the ‘#’ key on completion of the PIN entry.
4 Bit 4 Bits of data is output for each pressed key.
5 Bits of data is output for each pressed key with the last
4 Bit Parity
bit being ODD parity on the first 4 bits.
The number of bits that are sent relate to the key press’s
4 Bit Buffered
multiplied by 4. The data is buffered and only sent when
the user of the keypad press’s the Enter key on the keypad.
The number of bits that are sent relate to the key press’s
multiplied by 5, each key press is 4 bits followed by a last
4 Bit Par + Buf
parity bit. The data is buffered and only sent when the user
of the keypad press’s the Enter key on the keypad.
A 36 Bit Wiegand Keypad format typical of an IEI keypad
36 Bit (IEI S0)
which can be set to decode PIN numbers from 0-999999.
When a Wiegand 26 Bit or 36 Bit Keypad is used PIN numbers that are prefixed with
a 0 can not be used and a maximum pin number of 65533 can be used for 26 Bit and
999999 for 36 Bit. This is a limitation of the 26 Bit and 36 Bit Format and not the
Reader Expander. To utilize the full 8 digit capacity for the PIN number of a user
and allow prefixed PIN numbers select a PIN device that supports the ARK-501 or
Bit Buffered Outputs.
Reader Port 1 LCD Keypad
If the keypad operation mode is set to use one of the selected LCD keypads you can program
the address of the keypad to use for pin entry. When using this mode of operation the LCD
keypad will present a login message when a valid card is presented that requires pin entry.
RD001 R1 Keypad
None
Use the [1] and [3] keys to scroll the available keypad mode settings. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
Reader Port 1 Multi Badge Operation
Protégé Integrated System Controller Reference Manual
98