PRT CTRL Integrated Controller Reference Manual

If the required format is not shown or the format that you are using is not known
try the configuration with Auto Wiegand or Auto Magnetic. If the data fails to
decode contact Integrated Control Technology, we can attempt to create or find a
format solution for the reading device you are using.
Reader Port 1 Secondary Reading Format
The secondary reading format is used to program an alternate format for the reader expander
and has the same options as the standard reader selection. The secondary format will only be
used if the first format can not decode the card information that is received by the reader
interface.
RD001 R1 Format
None
Use the [1] and [3] keys to scroll the available card reader format settings. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
For a list of supported formats refer to the Reader Expander Format Table on Page
94.
Reader Port 1 Reader Type
The reader type informs the reader expander which location of the door the reader is installed
that is connected to the reader expander port one. The reader expander uses this information
to pass the correct direction of travel to the door control functions. For an access door this
should be set to ENTRY reader.
When using the reader with a door that controls an inside or outside area for arming or
disarmed or for global anti-passback the ENTRY and EXIT configuration must be set correctly
to ensure the correct action is taken by the reader expander.
RD001 R1 Type
ENTRY Reader
Use the [1] and [3] keys to scroll the available reader type settings. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
Arming Mode
ENTRY Reader
EXIT Reader
Operation
The reader is located on the outside of the door and is used
to enter in to the area that is being protected by the door.
This is the default setting and should be set for all general
access doors (single reader)
The reader is located on the inside of the door and is used
to exit out of the area that is being protected by the door.
If the reader expander is configured for multiplex
reader mode the multiplexed reader is ALWAYS the
EXIT reader.
Reader Port 1 Keypad Operation Mode
The keypad operation mode programmed for the reader on port one determines if the reader
port has a pin entry device attached or uses a local LCD keypad.
97 Protégé Integrated System Controller Reference Manual