PRT CTRL Integrated Controller Reference Manual

Multi 26/34 Bit
First 4 Track 2
Kantech 39 Bit
Setec 37 Bit
Motorola ABA T2
Hotel T2
32 Bit
32 Bit (Rev)
WSE 34 Bit
HID 32 Bit
First 6 Track 2
30 Bit
37 Bit
36 Bit
Rusco 40 Bit
ABA BIN T2
create the hash.
A multi bit format to allow the operation of both 26 and 34
Bit Cards on the same port. This can also be achieved by
using the secondary reader format.
The first 4 digits of a track 2 card will be used as the card
number and a site code of 0 will be generated.
A Kantech Systems of Canada format that uses 39 bits of
information with a 8 bit facility code and 24 bit card
number.
A Setec Card Reader format that is similar to the 37 Bit
format however overall parity is used in place of the
individual 4 parity bits.
Motorola Indala® produced card readers that were capable
of outputting a multiple format. These generated a format
similar to the Track 2 format however the number of digits
generated was based on the card programming data.
An encrypted format used for the hotel industry and
prevents the creation of cards. The hotel format can be
used with MANY key and lock manufactures. The Hotel
Format is not widely used and now slowly being replaced by
Smart Card technology. We recommend that this format is
not used and is included for legacy implementations.
A straight 32 bit format consisting of a single card serial
number and is typically used by Mifare® reading devices
when outputting data. This can also be sent using the 34
Bit formats.
Identical to the 32 Bit format above however the data is
sent in reverse order from Bit 32 to Bit 0.
Westinghouse® Security Electronics format. A 34 bit format
based on 16 Digit Family number and 16 Digit Card
Number.
HID® 32 Bit format has no parity and data is generated as
a complete 32 Bit data block.
The first 6 digits of a track 2 card will be used as the card
number and a site code of 0 will be generated.
The 30 Bit format consists of 2 14 bit blocks with parity and
a 8 digit facility code and 20 digit card number. Not a
common format and is typically found on older Smart Card
readers.
The 37 bit format is different to the first format and of 1
block of 35 bits of data which is broken in to a 20 bit card
number and 15 bit site code. This is commonly used with
older HID® readers.
A standard 36 Bit format which consists of 4 8 bit blocks
each with a parity bit. This is commonly used with the
Dallas one wire and Kwik Key products.
A Casi Rusco 40 Bit format used on the smart card readers
produced by Casi Rusco and WSE. The format will output a
24 bit card number and 10 bit site code.
American Banking Association Track 2 magnetic format that
uses the BIN (Bank Identification Number) stored in the
first 4 digits as the card number. This format can be used
to allow entry in to Bank ATM Foyers. By putting an access
level on the cards they can also be used to prevent access
at certain times and can be used to activate the lighting in
the ATM area when presented.
95 Protégé Integrated System Controller Reference Manual