PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the reader mode settings. For more information about the
list control data entry refer to the section List Control Data Entry on Page 406.
Operating Mode
Access
Elevator
Area Control
Operation
The reader expander port is used to control access through
doors. You must configure the door that is controlled by this
reader expander. This mode should also be used if control
of a lobby or elevator call button is required. To control a
elevator car use the Elevator Mode.
The reader expander is used to control access to floors
within an elevator. You must configure the elevator number
that is connected to the reader.
The reader expander input is used to ONLY control an area
for arming and disarmed. Please note that this can be
achieved using the Access Mode as well by integrating the
alarm and access control systems.
Reader Port 1 Controlled Door
The reader controlled door setting sets the door that the reader on port one will provide card
and control information to. It is possible that more than one reader has the same controlled
door (Entry and Exit reading configuration).
RD001 R1 Door
*Door 001
Use the [1] and [3] keys to scroll the available door settings. For more information about the
list control data entry refer to the section List Control Data Entry on Page 406.
Reader Port 1 Controlled Area
The reader controlled area setting sets the area that the reader on port one will control if the
reader mode is set as area control. If area control is selected the reader can not be used for
other functions. If you want to disarm and arm areas while using the reader to access the
door (integrated access and alarm) refer to the Reader Misc Options section on Page 101.
RD001 R1 Area
None
Use the [1] and [3] keys to scroll the available area settings. For more information about the
list control data entry refer to the section List Control Data Entry on Page 406.
Reader Port 1 Elevator Car
The reader elevator car is used when the reader port 1 mode of operation is configured for
Elevator Control mode. When configuring the elevator control mode you must also configure
the elevator number for the reader expander that the floor control relays are located on, this
is typically the same reader expander that the card reader is connected to. For information on
programming the elevator car refer to the Elevator Programming Section on Page 186.
RD001 R1 ElvNum
None
Use the [1] and [3] keys to scroll the available elevators. For more information about the list
control data entry refer to the section List Control Data Entry on Page 406.
93 Protégé Integrated System Controller Reference Manual