PRT CTRL Integrated Controller Reference Manual

Enabled the high current charging option will set 700mA charging in the
power supply system of the reader expander.
For reader expanders that do not have a power supply this option performs
no function.
Disabled the reader expander will set the standard 350mA charging in the
power supply system.
Option 2 - Multiple Reader Connected to Port 1
Enabled the reader will process the multiplexed reader inputs on Port 1 so
that dual readers can be connected for entry and exit processing. The
duplex reader that is connected will always operate as the exit reader.
Disabled the reader port 1 interface will operate as a single reader input.
Option 3 - Multiple Reader Connected to Port 2
Enabled the reader will process the multiplexed reader inputs on Port 2 so
that dual readers can be connected for entry and exit processing. The
duplex reader that is connected will always operate as the exit reader.
Disabled the reader port 2 interface will operate as a single reader input.
Option 4 – Virtual Module
Enabled a physical module can’t register at this address. This is used to
protect Zones, PGM’s etc that are used by functions.
Disabled modules can register as normal.
Option 5 – Invert Module Tamper
Enabled the reader expander will invert the module tamper input allowing a
normally open (door closed) tamper switch to be used.
Disabled the reader expander will use the standard normally closed (door
closed) tamper switch.
Option 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Reader Port 1 Mode
The reader mode setting determines what function the reader attached to port one will
perform.
RD001 R1 Mode
Access
Protégé Integrated System Controller Reference Manual
92