PRT CTRL Integrated Controller Reference Manual

O The 2 Reader expander is online.
('*' will indicate the expander is offline)
To view the IP address of the module press the [] key from this view. If the module is
connected over the RS-485 LAN “---.---.---.---“ will be displayed.
To list all offline or online modules refer to the Module Network Functions on Page 265.
Special functions are provided to update, update reset a module and request offline events
from a module. In the case of a update or update reset this occurs for the individual module
however pressing the memory key will start the event request process for the by using a
shortcut key directly from the keypad selection screen.
Key
[STAY]
[FORCE]
[MEMORY]
Function
Pressing the [STAY] key will update the zone expander number that is
currently displayed in the module selection window. This will program
the module WITHOUT resetting the module.
Pressing the [FORCE] key will update and init the zone expander
number that is currently displayed in the module selection window. This
will program the module and then restart the module.
Pressing the [MEMORY] key will start the system controller in the
offline event update mode. This forces the controller to request all
offline events from the Intelligent or Ethernet Reader Expanders.
Pressing the [MEMORY] key while the system controller is already
updating the network or performing other functions the [MEMORY] key
will not have any function.
Module Polling Time
The polling time defines how often the Reader Expander module checks in with the Protégé
System Controller. If a Reader Expander fails to check in, it triggers its associated
communication failure (RDxxx:16) trouble zone and the trouble zone for a general module
communications failure.
To enter a polling time (008 to 250 seconds), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER]. By default the Reader Expander polling
time is set to 250 seconds. Setting a polling time below 60 seconds should only be done for
Reader Expanders that are in a non-secure area.
RD001 Polling
time: 250 secs
For UL and cUL listed installations you MUST set the polling time to 180 seconds or
less.
Reader Expander Module Options
Options that relate to the reader expander module can be set using option entry.
RD001 Module
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - High Current Charging
91 Protégé Integrated System Controller Reference Manual