PRT CTRL Integrated Controller Reference Manual

When programming modules some options are processed at the module, for these options to
operate correctly a network update must be performed and the zone expander must be
registered and online.
Updating modules can be accessed by selecting [MENU, 4, 8, 1, 3], you can also check the
status of your modules by selecting [MENU, 4, 8, 1, 1] for all modules presently offline and
[MENU, 4, 8, 1, 2] for all online modules. For more information refer to the advanced menu
section on page 265.
Selecting a Reader Expander to Modify
Each Reader expander is assigned a unique address from 001 to 250. Programming the
address of the Reader Expander Module (PRT-RDI2, PRT-RDM2, PRT-RDS2 and PRT-RDE2) is
covered in the installation instructions included with your Reader Expander Module.
2 Reader Exp to
modify: RD001
Type the appropriate 3-digit Reader Expander address or use the [] and [] keys. When the
desired address appears on the screen, press [ENTER] to program the selected Reader
Expander module. The maximum number of Reader Expanders that can be programmed is
limited by your system’s memory and configured profile.
Displaying Selected 2 Reader Expander Information
It is possible to show the current 2 Reader Expander registration and information details
(registration, online and version) from the 2 Reader Expander selection display.
2 Reader Exp to
modify: RD001
Type the appropriate 3-digit 2 Reader Expander address or use the [] and [] keys. When
the desired address appears on the screen, press the [ARM] key to display information on the
selected 2 Reader Expander. The screen will now display information about the 2 Reader
Expander that was selected. Press any other key to return to the 2 Reader Expander selection
window.
11-14-72-B9 [23]
V 1.31 2404 M RO
The display above represents the following information for the selected keypad:
11-14-72-B9 Serial Number of the registered 2 Reader Expander at the
selected address.
[23] The current polling timeout value.
V 1.05
Software version of the registered keypad.
2404 Software version build number.
M
This is the module type that is registered at this location.
M Mini 2 Reader Expander
S Standard 2 Reader Expander
I Intelligent 2 Reader Expander
E Ethernet 2 Reader Expander
R
The 2 Reader expander is registered.
('*' will indicate no expander registered)
Protégé Integrated System Controller Reference Manual
90