PRT CTRL Integrated Controller Reference Manual

Enabled the high current charging option will set 700mA charging in the
power supply system.
For PGM expanders that do not have a power supply this option performs no
function.
Disabled the high current option will set the standard 350mA charging rate
in the power supply system.
Option 2 – Invert Module Tamper
Enabled the PGM expander will invert the module tamper input allowing a
normally open (door closed) tamper switch to be used.
Disabled the PGM expander will use the standard normally closed (door
closed) tamper switch.
Option 3 – Stage PGM On/Off
Enabled the PGM expander will not activate any two local PGMs within 50ms
of each other. E.g. If PGM’s 1 to 4 were activated at the same time the
PX16 would activate PGM 1 first then delay 50ms and activate PGM 2,
cotinuting like this until all 4 PGMs were activated.
Disabled the PGM expander will turn on or off all PGM’s instantly.
Option 4 – Virtual Module
Enabled a physical module can’t register at this address. This is used to
protect Zones, PGM’s etc that are used by functions.
Disabled modules can register as normal.
Option 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Reader Expander
To access the Reader Expander module programming login using a valid installer code and
then select [MENU, 4, 1, 3]. The screen displays “Reader exp to modify” as shown in the
following example.
2 Reader Exp to
modify: RD001
Every time you press the Enter key, the next screen appears. The different screens are
described in the following sub-sections. Programming the Reader Expander allows you to set
the polling time of the module, power supply options and the configuration of the readers with
associated doors.
89 Protégé Integrated System Controller Reference Manual