PRT CTRL Integrated Controller Reference Manual

To enter a polling time (008 to 250 seconds), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER]. By default the Zone Expander polling time
is set to 250 seconds. Setting a polling time below 60 seconds should only be done for zone
expanders that are in a non-secure area.
ZX001 Polling
time: 250 secs
For UL and cUL listed installations you MUST set the polling time to 180 seconds or
less.
Zone Expander Module Options
Options that relate to the zone expander module can be set using option entry.
ZX001 Module
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - High Current Charging
Enabled the zone expander will enable 700mA charging in the power supply
system.
Disabled the zone expander will enable 350mA charging in the power supply
system.
Option 2 – Virtual Module
Enabled a physical module can’t register at this address. This is used to
protect Zones, PGM’s etc that are used by functions.
Disabled modules can register as normal.
Option3 – Invert Module Tamper
Enabled the zone expander will invert the module tamper input allowing a
normally open (door closed) tamper switch to be used.
Disabled the zone expander will use the standard normally closed (door
closed) tamper switch.
Option 4, 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
PGM Expander
Protégé Integrated System Controller Reference Manual
86