PRT CTRL Integrated Controller Reference Manual

Option 3 - Event Review Menu
Enabled the keypad will allow access to the Event Review Menu if no user is
logged in and a user press's the [MENU] key.
Disabled the keypad will not allow access to the Event Review Menu offline.
Option 4 - Keypad Information Menu
Enabled the keypad will allow access to the Keypad Information Menu if no
user is logged in and a user press's the [MENU] key. It is recommended to
leave this option enabled.
Disabled the keypad will not allow access to the Keypad Information Menu
offline.
Option 5, 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Zone Expander
To access the Zone Expander module programming login using a valid installer code and then
select [MENU, 4, 1, 2]. The screen displays “Zone exp to modify” as shown in the following
example.
16 Zone Exp to
modify: ZX001
Every time you press the Enter key, the next screen appears. The different screens are
described in the following sub-sections. Programming the Zone Expander allows you to set
the polling time of the module and power supply options.
When programming modules some options are processed at the module, for these options to
operate correctly a network update must be performed and the zone expander must be
registered and online.
Updating modules can be accessed by selecting [MENU, 4, 8, 1, 3], you can also check the
status of your modules by selecting [MENU, 4, 8, 1, 1] for all modules presently offline and
[MENU, 4, 8, 1, 2] for all online modules. For more information refer to the advanced menu
section on page XXX.
Selecting a Zone Expander to Modify
Each zone expander is assigned a unique address from 001 to 250. Programming the address
of the Zone Expander Module (PRT-ZX16) is covered in the installation instructions included
with your PRT-ZX16 Zone Expander Module.
16 Zone Exp to
modify: ZX001
Protégé Integrated System Controller Reference Manual
84