PRT CTRL Integrated Controller Reference Manual

Enabled the keypad will lockout any user activity for the programmed
lockout time if three invalid PIN numbers are entered. This option will have
no affect if the lockout time is programmed to 0 seconds.
Disabled the keypad will perform no action on an invalid PIN.
Option 4 - Keypad Lockout
Enabled the keypad will allow the [CLEAR] / [X] key to disable the beeper
on the keypad. You must hold the key for two seconds.
Disabled the [CLEAR] / [X] will not perform any action.
Option 5 – Virtual Module
Enabled a physical module can’t register at this address. This is used to
protect Zones, PGM’s etc that are used by functions.
Disabled modules can register as normal.
Option 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Keypad Display Options
The following options determine which screens will be displayed when the keypad is offline.
The keypad is offline when no valid user code (PIN) has been entered. By default the keypad
will display the system message programmed in to the panel configuration settings.
KP001 Display
[1-------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
If all message options are disabled the LCD Keypad will display a standard system is ready
message on the display.
Option 1 - System Message Display
Enabled the keypad will display the text programmed in the panel system
message setting.
Disabled the keypad will not display the system text message.
Option 2 - Primary Area Status Display
Enabled the keypad will display the status of the primary that is assigned to
the keypad.
Disabled the keypad will not display the primary area status.
Protégé Integrated System Controller Reference Manual
80