PRT CTRL Integrated Controller Reference Manual

Door Group Name
If the selected door group has a name associated (some door groups do not have a name
associated with them) the name programming screen will be shown.
DG001 Name
All Doors
To scroll door groups by name use the [] and [] keys. To modify or enter a new name for
the selected door group use the keypad as explained in section Entering Text and Names on
Page 406 and press [ENTER].
By default the door group name will be prefixed by an '*' this indicates that the name is an
editable name in the system.
Operating Schedule
The operating schedule for the door group determines when the door group is valid and if it
will use a secondary door group if the schedule is not valid. A schedule is a series of times
and days that can be programmed to prevent the operating of functions based on a 7 day
week and 24 hour clock. For more information on the programming of the schedule refer to
the Schedule Programming section on Page 344.
DG001 Schedule
None
Use the [1] and [3] keys to scroll the schedule selection and press [ENTER] to select the
schedule displayed. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
Secondary Door Group
A secondary door group can be selected that will be used when the schedule of the door
group that is programmed is not valid. The schedule of the secondary door group must be
valid or set to none. The secondary door group allows very powerful door group controls to be
placed on users during certain times of the day preventing access to certain doors.
DG001 Secondary
None
Use the [1] and [3] keys to scroll the secondary door group selection and press [ENTER] to
select the door group displayed. For more information about the list control data entry refer
to the section List Control Data Entry on Page 406. Programming a secondary door group that
uses the current area group being edited will perform no function.
Door Group Assignment Blocks 1 to 32
The door group assignment blocks assign a door to the group that is being programmed. Each
block is 8 doors and the number of door blocks that can be programmed depends on the
number of doors that the system is configured to manage. For example if there are 64 doors
there will be 8 blocks of 8 doors. Block 1 option 1 will refer to Door 001 and Block 8 Option 8
will refer to Door 064.
Protégé Integrated System Controller Reference Manual
58