PRT CTRL Integrated Controller Reference Manual

AG001 Name
All Areas
To scroll area groups by name use the [] and [] keys. To modify or enter a new name for
the selected area group use the keypad as explained in section Entering Text and Names on
Page 406 and press [ENTER].
By default the area group name will be prefixed by an '*' this indicates that the name is an
editable name in the system.
Operating Schedule
The operating schedule for the area group determines when the area group is valid and if it
will use a secondary area group if the schedule is not valid. A schedule is a series of times
and days that can be programmed to prevent the operating of functions based on a 7 day
week and 24 hour clock. For more information on the programming of the schedule refer to
the Schedule Programming section on Page 344.
AG001 Schedule
None
Use the [1] and [3] keys to scroll the schedule selection and press [ENTER] to select the
schedule displayed. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
Secondary Area Group
A secondary area group can be selected that will be used when the schedule of the area group
that is programmed is not valid. The schedule of the secondary area group must be valid. The
secondary group allows very powerful area group controls to be placed on users during
certain times of the day.
AG001 Secondary
None
Use the [1] and [3] keys to scroll the secondary area group selection and press [ENTER] to
select the area group displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406. Programming a secondary area group that
uses the current area group being edited will perform no function.
Area Group Assignment Blocks 1 to 32
The area group assignment blocks assign an area to the group that is being programmed.
Each block is 8 areas and the number of area blocks depends on the number of areas that the
system is configured to manage. For example if there are 32 areas there will be 4 blocks of 8
areas. Block 1 option 1 will refer to Area 001 and Block 4 Option 8 will refer to Area 008.
AG001 Block 1
[12345678]
To modify the block setting options, follow the settings as explained in section Entering Data
Options on Page 409.Use the relevant key from 1 to 8 to toggle the state of the option.
Protégé Integrated System Controller Reference Manual
56